Klein-tools VDV501828 Bedienungsanleitung PDF herunterladen (Seite 4)

Performing a Cable Test

Press the "On/Off" button to power on the

VDV Commander.

• Connect a network, coax, or telephone cable to the

appropriate connector on the top of the VDV Commander.

WARNING: Do NOT plug an RJ12 cable directly into the VDV

Commander. A standard RJ12 cable will damage the VDV

Commander’s RJ45 jack. Use the RJ adapter patch cable

(VDV726-125) that is included with the VDV Commander.

• Press the "Enter" button to display the cable test

menu. The VDV Commander will automatically perform a

test upon entering the cable test menu.

• To scroll through Cable Type mode, press the RJ45

function button. The icon will change with each press, from

RJ45 to coax to telephone / / .

• If a Test-n-Map

remote is NOT being used (a one ended

test), the VDV Commander will test the length of each pair,

open, short, or split pair. Performing a one ended test will not

verify connectivity on the opposite end of the cable.

• If a remote is being used, connect the remote to the opposite

end of the cable.

• To calibrate the VoP, connect a known length of cable to the

VDV Commander and press the up/down/left/right buttons to

increase or decrease the VoP. Press the left and right buttons

to select and change the VoP one digit at a time.

• While adjusting the VoP, press the test button until the desired

length of the cable is displayed.

• To save the calibrated VoP, enter the settings menu and press

the

"Save" function button .

NOTE: your adjusted VoP will be displayed next to the

RJ45 or coax icon.

• Press the green test button or the loop mode

function button to perform additional tests.

GENERAL TESTING PROCEDURES

1 2 3 4 5 6 7 8 9 ... 39 40

Keine Kommentare

Klein-tools VDV501828 Bedienungsanleitung Seite 4